The reports of the CJ-7 were different in each type of engine: the 145 cu in (2.4 L) diesel was mated to the 4.10 ratio axle (in both Renegade and Laredo), while the 258 cubic-inch straight six and 150 cubic-inch four-cylinder used 3.73 and AMC V8 304-powered models (produced 1976-1981, which became part of the Golden …

Will a YJ body fit on a CJ frame?

The CJ-7 tail gate hinges on the bottom and opens “pickup” style whereas the YJ tail gate hinges on the passenger’s side and opens “swing out” style. … We do not install the fuel filler onto our body and the mounting pads have been enlarged with no holes, enabling our body to fit onto both the CJ-7 and the YJ frame.

What's the difference between a YJ and a CJ Jeep?

The Jeep Wrangler YJ is a successor to the civilian Jeep (CJ). The only difference between the Jeep CJ and Jeep Wrangler YJ’s suspension, were that the YJ’s leaf springs were much wider. Despite the new front grill, the body is very similar to the CJ7’s. … This Wrangler YJ is a hard to find.

What axles does a YJ have?

Identifying the axles in YJs is pretty simple since there were no options for it. Every YJ came with a Dana 30 up front and a Dana 35 in the rear. TJ Wranglers will have either a Dana 30 in the front and a Dana 35 in the rear unless you have a Rubicon model. In which case you’ll have 44s front and back.

What is Dana 30 axle?

The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions.

Are Cj7 and YJ doors the same?

CJ-7 doors are pretty much the same thing as YJ doors.

What is a Dana 44 rear end?

The Dana/Spicer Model 44 is an automotive axle used extensively among automobile manufacturers and in the automotive aftermarket. The Dana 44 is manufactured for both front and rear axle variants. The Dana 44 has been manufactured as a beam axle and independent suspension for both front and rear axle setups.

Are TJ and YJ tubs the same?

all tj tubs are the same and will just bolt on. i was going to say the same thing about cherokee doing a yj tub swap.

What is the difference between a jeep Cj5 and a Cj7?

The difference between the Cj5 and Cj7 models is that Cj5 is smaller in size and had a manual transmission. Cj7 is comparatively more massive, with the addition of a more extended wheelhouse to allow automatic transmission. … Here, a longer wheelbase was introduced to allow the jeep to have automatic transmission.

Can a Dana 30 handle 35s?

Yes, you may twist your axle housing or explode the carrier running 35s, but you could do just the same running 33s. … Dana 30 (and 44) JK frontends will also benefit greatly from the installation of HD ball joints, axle shafts, and extra housing reinforcement, such as a truss.

Article first time published on

Is a Dana 44 a good axle?

At the same time, the Dana 44 is a great axle if you don’t need giant tires or big power. Most people don’t realize how heavy a Dana 60 is and how much unsprung weight affects handling. The Dana 44 is also a heavy axle, but it’s significantly lighter than a Dana 60.

What axles are in a Jeep LJ?

Finally, those original LJ Unlimited owners (2003-06) have a Dana 30 front and Dana 44 rear. Moving on to the JK Wrangler edition (2007-18), original owners have front Dana 30 axles except for those with a Rubicon trim level as these, again, are front and rear Dana 44s.

Is a YJ longer than a CJ?

Unlike the CJ vehicles, the YJ has a longer wheelbase, and less ground clearance. … The YJ wranglers replaced the CJ in 1987, after the manufacturers stopped its production. 2. Although both the CJ and YJ jeeps have a leaf-spring suspension, the springs of the YJ are much wider than those of the CJ jeeps.

Why are CJ jeeps so expensive?

They are expensive due to the fact that it is widely considered the most capable off-road vehicle available on the market today. This model is also a blank slate for those who enjoy making alterations and customization for their vehicle, with Jeep offering numerous variations of the Wrangler for purchase.

What does Jeep CJ stand for?

In 1944, Willys-Overland, one of the two main manufacturers of the World War II military Jeep, built the first prototypes for a commercial version – the CJ, short for “civilian Jeep”.

Are TJ and YJ axles the same?

YJ Wranglers came with a Dana 30 front axle and a Dana 35 rear axle, while the TJ came with a Dana 30 front axle and a Dana 35c in the rear. … One of the more significant differences between the YJ and the TJ has to do with the frame and suspension.

Is Dana 30 full float?

Dana 30. Model 30: Drive-type, full floating axle with open end steering knuckles mounted on ball studs.

What's the difference between a Dana 30 and a Dana 44?

The only difference between the JK Dana 30 and Dana 44 is ring gear size, electronic locker, and bigger shafts. … You’re better off just starting with an aftermarket Dana 44 that is a “true 44”.

What does Regearing a Jeep do?

Regearing refers to the process of changing your pinion gears and ring gears to a different ratio, which changes the balance of torque and speed. Regearing your Jeep is a crucial step in adjusting the size of your tires since improper gearing can result in more stress being transferred to the axle.

What did a Dana 60 come in?

The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover.

What are Dana 60 axles?

The Dana/Spicer Model 60 is an automotive axle used in OEM applications by Chevrolet, Dodge, Chrysler, and Ford. There are rear axle and four wheel drive front steering versions of the Dana 60. It can be readily identified by its straight axle tubes, 10 bolt asymmetrical cover, and a “60” cast in to the housing.

Will a CJ7 soft top fit a YJ?

As long as it was a CJ7, and you have the hardware for it, then it will bolt right on. CJ5 is too short, and the stock YJ hardware is made different than the CJ7.

What is a CJ7 worth?

A: The average price of a Jeep CJ7 is $25,859.

What year did they stop making CJ7?

Produced from 1981 to 1986, about 28,000 models were sold. The CJ7 was one of the most successful Jeep models, with numerous special packages. Close to 400,000 were produced by the time it was discontinued.

Is a CJ5 wider than a CJ7?

The CJ7 is, in fact, larger than the CJ5. The shorter CJ5 was even expanded at one time, growing from the wheel base about 2 ½ inches, in 1972. This brings the wheel base measurement of the CJ5 to 83 ½ inches. … Thus, you can easily find that there is as much difference as 10 inches between the CJ5 and the CJ7.

What is a 78 CJ7 worth?

**Figure based on a stock 1978 Jeep CJ-7 valued at $16,000 with OH rates with $100/300K liability/UM/UIM limits. Actual costs vary depending on the coverage selected, vehicle condition, state and other factors.

What does the YJ stand for in Jeep?

Hard-core Jeepers said its code name, YJ, stood for “Yuppie Jeep.” Chrysler Corporation bought AMC that same year, and took the lessons learned from the YJ to create the next-generation Wrangler, code named TJ.

What is a Jeep CJ7?

The Jeep CJ7 This 2-door Jeep SUV first hit the road in 1976 and was a popular pick for the adventurous driver for years to come. … A variety of engines were packed into the Jeep CJ7, including the famous 5.0 AMC 304 V8 found in the Golden Eagle edition, and the 4.2-liter I6 found in the Limited trim option.

What are the worst years for Jeep Wrangler?

The 2012 Jeep Wrangler was voted the worst model year One of the newer models, the 2012 Wrangler is actually the worst rated Wrangler overall according to Car Complaints. With nine recalls, it didn’t top out the list for most recalls but it was also involved in one of the largest recalls.

What years are Jeep YJ?

Jeep Wrangler YJAlso calledJeep YJ (Canada)ProductionMarch 1986 – December 1995 (Canada, U.S.) 1989–2001 (Iran)Model years1987–1996AssemblyToledo, Ohio, United States Brampton, Ontario, Canada (Brampton Assembly) Tehran, Iran (Pars Khodro) (Ensambladora Carabobo) Venezuela

Can a Dana 30 Handle 33 inch tires?

The 30 is fine up to 35″ tires without a locker before upgrades are normally needed. 33’s are as far as I would push the Dana 35. If you do more than easy-medium trails I would really look at upgrading.